Set machine up on truck and the system was completely empty. Pulled vacuum for 30 minutes. Vacuum held for nearly an hour. Spoke with customer regarding possibilities of a leak after a recharge was completed. He opted to recharge system and hope for the best. Once system was recharged, AC is blowing ice cold.
Tech confirmed rear brake shake. Machined rear brake drums as needed . Reassembled and road tested after. Rear brake shake corrected. Has a minor brake pulse in front brakes and a minor shake from a balance in the front tires.
Phil T. gave our service a 5 star review on 7/21/2023
2009 Toyota Tacoma CRM Mitchell1
2023-07-22T22:01:55+00:00
Vehicle had a compression union used to repair the brake line along the frame. Ran a new line aling the frame to the rear axle. Ran a new line to the left rear wheel. During the bleeding process, the tubing in the right front along the frame rail near the engine began leaking. Replace the tubing to the RF hose as well. Finished bleeding brakes as needed.
Tech had to cut lower portion of frame to open it up and remove the rust in between the frame sections to be able to plate it accordingly. Tech found two other sections in the right front frame area on the outside that needed to be patched during the process. Repaired all sections as needed for MSI.
Three tire pressures were at about 25 psi. Set all pressures to 37 psi and reset TPMS indicator.
David C. gave our service a 5 star review on 5/26/2023
2007 Toyota Tacoma CRM Mitchell1
2023-05-27T22:01:57+00:00